Categories

False alarms and system malfunctions can be exasperating, and even worse, may prevent your home security system from working the way it should. Luckily, most troubles, from false alarms to dead batteries, are straightforward to correct. Explore our suggestions for troubleshooting your home alarm system in Cleveland. We’ll help you keep your family safe and your system running smoothly.

Test Your Home Security System In Cleveland

One great way to troubleshoot your property’s security is to test it! The latest systems let you put them in test mode to avoid initiating an emergency response. Once you’re in test mode, take these steps:

• Activate your system as you would when going out.
• Open a door or window protected by a contact sensor, or test other devices. Close the door or window once you’re finished so it doesn’t prompt the alarm when you leave test mode.
• Permit the alarm to go off for 60 seconds to ensure communications with the security provider and to produce an entry in the alarm activity log.
• Proceed to test equipment as you wish
• Review the alarm’s activity log to validate that everything’s working.

Don’t worry, monitoring agents can tell that your alarm system is being tested. Just make sure to switch out of test mode when complete. It’s a good idea to test every other month or whenever you adjust your home’s internet or phone connectivity.

Check The Position And Condition Of Motion Sensors

Although an integral part of your alarm system, motion sensors are notorious for false alarms. Do your part to prevent them with a few simple troubleshooting steps.

• Perform a physical check. Is there anything that could shift within the sensor’s detection range, like a curtain taken by a breeze?
• Is the sensor covered in dust? Cobwebs, dirt, and debris can cause malfunctions. Make sure the device is clean.
• Does the motion detector come with pet immunity you can turn on? Some sensors can be programmed to ignore pets weighing up to 100 pounds.
• When was the battery changed? Low batteries might impact performance or cause false alarms.
• Is the sensor facing a heat source? Excess heat from sunlight or a fireplace can set off an alarm.

Keep Batteries On Hand And Look Out For Low Battery Signals

One of the great advantages of new home security systems is that they’ll alert you when batteries are dying. If your system uses a smartphone app or control panel, you’ll typically see alerts there. Depending on your alarm, you could hear an occasional beep when batteries are running out. 

Motion detectors, smoke detectors, contact sensors, and other wireless tools have batteries that need to be replaced every 1 to 2 years. It’s a good idea to keep batteries on hand and set a replacement schedule. Many systems also come with a backup battery for the main control panel. This battery helps keep your system running if you have a power outage and should recharge itself once the electricity is working again. If it doesn’t, you will have to replace it.

Troubleshooting Is Simple With ADT Home Security In Cleveland 

As the leading name in home security, ADT creates systems that provide unrivaled protection and functionality. Getting into test mode is easy through MyADT.com or the ADT+ app, and you’ll always be sent updates when a sensor battery is nearing depletion. Reach out to Secure24 Alarm Systems, an authorized ADT dealer, to get more details and design a system perfect for your Cleveland home and family. Place a call to (216) 273-8448 or submit our form today!